Page 7

Photo Manual

Compumarine Boat Plans
Cedar Strip Small Craft Construction

This photo shows the Power Dinghy molds set up on the strongback ready to start bending on the strips. Notice how station 0 with the stem piece attached is installed on the end of the strong-back. This station should be attached using wood screws, which must be removed before lifting the finished hull off the molds. Station 0 remains in the finished hull.

Refer to the drawing in the manual showing the station molds set up on the strongback. Be sure to attach station molds on the correct side of the mold support pieces. Notice that on two ended hulls like this canoe, station 10 with the stern mold attached also stays in the finished hull. Attach station 10 to the strongback with wood screws.

Back    Next

|1|2|3|4|5|6|7|8|9|10|11|12|13|14|15|
|16|17|18|19|20|21|22|23|24|25|26|27|28|
|29|30|31|32|33|34|35|36|37|38|39|40|41|

| Home | Boat Plans | Boats | About Us | How To | Contact Us | Privacy Statement | Links | Completed Boats |
| The Classic Dinghy | The Power Dinghy | The Yacht Tender | The Fisherman | The Classic Canoe |

This Web Site is maintained by John R Clark, JRC Web Design,  
Last updated September 15, 2011

Copyright 1989 - 2008 © Compumarine, All Rights Reserved